Name: Universal LED mirror lights， mirror plastic bumper
Voltage: DC-12V
Size: 16.5X2.5cm
Weight: 6.64
Features:
1. Use soft circuit board and 3M adhesive on the back， can be installed in the rear-view mirror has a curvature of the surface can be bent according to require proper installation;
2. can be accessed by bending light or small lamp;
3. high temperature， waterproof material， durable;
4. Using ultra-thin， ultra-bright LED;
5. Environmental protection， low power consumption， high brightness， easy installation， a variety of models GM;
Installation Notes:
Method (a): the mirror must be removed when
1. The first product is bent with the same curvature of the mirror.
2. Then forced posted up.
3. Remove the car tripod.
4. Loose screws， remove the mirror.
5. The wires from the tripod through the hole into the car.
6. Use double-sided adhesive fixed to the bottom of the wire in the mirror， it is not easy to see wires.
7. Use the space to wire to the engine room， connected to a small lamp.
8. Perfect installation.
Method (2): The split mirror when not required
1. The first product is bent with the same curvature of the mirror.
2. Then forced posted up.
3. Use double-sided adhesive fixed to the bottom of the wire in the mirror， it is not easy to see wires.
4. Wires attached to the door along the side mirror.
5. Use the space to wire to the engine room， connected to a small lamp.
6. Perfect installation.
7. You can still be seen from the rear lights.
8. Perfect installation.
