3/8', Undersink Water Filter Housing Wrench.
3/8 inches
Undersink Water Filter Housing Wrench
Housing Wrench
3/8' Wrench
Use the SW-1 wrench to loosen bottom of housing during cartridge replacement. Slide circular end over housing until a snug fit and unscrew.
Do not use the SW-1 wrench to tighten the bottom of the housing. Only hand-tighten the bottom of the housing onto the cap to prevent cracking.
The SW-1 makes changing water filters easy.SW-1 and SW-1A assure you that the product is the same, and the listing is correct, as the product is a direct comparable to the Pentek-SW-1
The SW-1 spanner wrench can be used with Slim Line and 3G housings.
The SW-1 wrench is approximately 4.25-Inch Wide. (Note: Width is slightly less at the notches.)

Technical Details

Product Details

Product Dimensions

Package Dimensions
Width : 4.8 inch
Height : 0.6 inch
Length : 10.8 inch

Item Weight: 3.2 ounce (View shipping rates and policies)
Shipping Weight: 3.2 ounce (View shipping rates and policies)

ASIN : B000BQPAAS