A whole length is about 14CM width is about 10CM or so a bullet holediameter is about 8CM

6 big hole of whole length is about 14CM width is about 10CM or so a bullet hole diameter is about 6CM

The 24 hole is a length of about 14CM width is about 10CM or so eachbullet hole diameter is about 2CM

6 small hole whole length is about 14CM width is about 10CM or so a bullet hole diameter is about 5CM

Product description:

Reflective stickers and non reflective stickers the shop sold are carvestickers， non printing or printing stickers (advantages: carve sticker 3 ~ 5 years is not easy to fade， and digital printing and printing stickers， after several months of wind and rain sun， will fade. So most of the riders are chosen to carve sticker).

The owner mount steps:

The 1 body to mount position cleaning clean， and with a clean towel to dry state.

A small sticker pasting method:

2 directly to the sticker paper torn off the bottom， stuck on the mount part，scraper (scraping or bank card).

3 finally， carefully remove the top of the transfer film stickers.

Large sticker pasting method (100 cm above the sticker):

2 prepare a watering can， together with clean water detergent (detergent is the role of lubrication， unable to move. Avoid the location wrong) ; soft cleantowel; hot air gun (or hair dryer) a.

Spray again 3 with detergent water will mount position and then evenly，moist.

The sticker on the back of the 4 paper torn off the bottom， attached to themounting position， because it is the big stickers， should first fixed side， then fixed on the other side.

5 stickers center as the origin， with a plastic scraper to scrape around even，its purpose is to scrape out the water， so as not to leave the bubble; if there is a small amount of sand， the sticker corner lifted， the sand was removed，continue to scratch.

6 all after scraping a good， keep 15 ~ 20 minutes， let the sticker is completely dry， and then transfer film stickers surface torn off; if the stickerfast dry， with a hot-air gun gently blowing to heat (note distance)， the stickerafter transfer film can be torn off.

Matters needing attention:

Be careful of the 1 mount， avoid don't let sticker itself pasted together.

2 three days do not wash the car， because this time is still not fully pastedstickers， high-pressure water washing will affect the. Three days after thecar is no harm.

Buyers must read:

1 because of some big size stickers in packaging the delivery process isrolled up， cause sticker at the end of the paper and transfer film somebubbles， there are at the end of the paper some wrinkles， please rest assured， this is a normal phenomenon， does not affect the paper quality and mount process. But in the mount before the sticker shop in the flat on the desktop， a scraper (scraping or bank card).

The production of 2 reflective material stickers will produce differentreflection effect and colors in the light of different and different illumination angle， Taobao online product pictures for the reflective stickers in reflecting effect under vertical photo camera flash， its effect is equivalent to the evening light irradiation effect， please owners friend understanding， and tolerance pictures and objects in general color difference!