Anti Bark Rechargeable And Waterproof Training Collar PET 850

If need more receiver collar ，please contact me freely ，thanks !

we test them one by one before shipping to sure all work well !

with retail box !

 

Main features:
1.Vibration Mode (V) warning prior to the stimulation
2.6 intensity levels (2-7) for a wide variety of dispositions
3.7 sensitivity levels (1-7) adjustable for different dogs and environments
4.Easy testing method to check the no bark collar
5.Waterproof and Rechargeable
6.Multi-color led battery life indicator

  

 

On-off&intensity dial
This dial is to turn the petainer on/off and select the intensity level of stimulation
“Off ”position is to turn off the petainer
Level V- the petainer will vibrate only
Level 2 is lowest electrical stimulation and level 7 is the highest.
Form Level 2 to Level 7， the petainer will all vibrate first and then follow by electrical stimulation.

Sensitivity dial
The sensitivity dial is to adjust the sensitivity to the dog bark according to the environments the dog is in.
Level T is the most sensitivity and level 1 is the lest
When testing the petainer set it to the level T

Indicator Oight (LED window) and charge the petainer
When turn the petainer on the Green LED light will flash every 2 seconds .If the dog does not bark over 10 seconds， it will turn to the Sleep mode and the LED will turn off 
In the Sleep mode，the bark will activate the petainer automatically.

Auto-protection mode
If the petrainer keeps activates for 5 times. it will enter into auto-protection mode The LED indicator will turn to a blinking red and green for 1 minute. And then it turns off which means the petrainer goes to sleep mode.
Before going into Sleep mode， when the LED indicator turns to a blinking red light， the battery needs to be recharged. When starting to charge， the blinking red light will stay on red light. If it is fully charged， the red light will turn to the green light.
1 Open the Battery Charging Rubber cover on the No bark Collar and plug in and connect the USB connector to the adaptor.
2 plug the lithium polymer charger into an electrical power outlet of ordinary household voltage (110-230V)depending on your local standard.
3 fully charged with 3 to 4 hours.

Strap Installation
To install the petrainer strap， first unscrew the contact points and put screws in desired holes ，the tighten the contact points as shown below.

Testing
1. Turn the petainer on by turning off & intensity dial and set to the V mode
2. Set the sensitivity dial to the “T” level
3. Test by scratching the rough surface of the test tool on the petainer (as shown in the diagram) using a fingernail or pen. The petrainer will emit a vibration for 1.5 seconds. Then repeat the same process if you want to try it again.
When the No Bark Collar emits a vibration， a stimrlation is not emitted at the same time.
When you set the dial on the TEST level， it may be sensitive enough that the no bark collar can be activated easily by a small sound or tap.
NO bark collar: 3.7V 180mAh lip

 

';