APM Current!#!amp!*!amp;Voltage Sensors For APM2.5\/2.6\/2.8 PX4 Flight Control 3 In 1











Description:
Item Name:APM Current!#!amp!*!amp;Voltage Sensors
Voltage Input:2S-6S
Voltage Sampling: 10\/1
Output sub-line: 6-way
BEC Output: 5.3V \/ 3A (PWM switching)
Installation pitch: 45mm x 45mm
External dimensions: 50mm x 50mm
Usage:for APM2.5\/APM2.6\/APM2.8\/PX4 Flight Control

Features:
Integration of galvanometer，UBEC，sub panels as a function of APM current!#!amp!*!amp;voltage sensors
Compatible with APM2.5\/APM2.6\/APM2.8\/PX4 Flight Control
PCB using double-sided 3 times copper immersion gold process，excessive current is stable and reliable
The onboard 5.3V \/ 3A switching power supply UBEC
Current and voltage sampling circuit compatible 3DR galvanometer， without calibration， you can connect flight control and simple settings then it can be used

Using methods:
Board marked B +， B- is to connect the battery input terminal，the output terminal is six pairs of pads arranged side by side，respectively + - as a standard for welding ESC power lines.
Make sure that the correct welding.
Galvanometer connect with APM through a 6PIN signal cable，APM terminal please insert labeled PM's 6 hole socket，and unplug the JP1 jumper cap.
Prevent galvanometer power supply and power transfer in parallel which is not allowed， unless your ESC does not have BEC output.
Special Note: Compatible with standard version APM，please pay attention to the line sequence of APM and distributor wiring board.
After connecting，set the current!#!amp!*!amp;voltage sensors in the following photo in the MP then it can be used.



Package Included:
1 x 3 in 1 galvanometer board
1 x 15cm 14AWG red silicone cord
1 x 15cm 14AWG black silicone cord
1 x XT60 battery connector plug(1 pair)
1 x 6PIN power supply signal line(1 set)
1 x Heat Shrink Tubing(1segment)