Baby: autumn mountain track car

Product material: reflective material (carving)

Product specifications: 45X42cm

Product color: White + Red

Small car with the transparent film installation method (dry paste method):

Tools: large car cloth， scraper or credit card transparent film installation method (wet sticking method):

Tools: cloth， water glass， scraper or credit card

1， clean body， keep dry.

2， determine the need to place. In general， slowly pastes， side with the toolsto scrape， and propose the paper.

3， if the graph is not， can also make the transparent film and label all tearpaste. But be careful， don't happen adhesion.

4， after a good stick， and then repeatedly scraping pressure several times.Remove the transparent film.

5， in the doors and sewn with knife knife， inward package fu.

6， don't let the car and the car body has any separation or protuberance.

A large car with the transparent film installation method (wet sticking method):

Tools: cloth， water glass， scraper or credit card

1， clean body， sprinkle water -- to reduce viscosity， easy to adjust the position of the sticker will be posted on the body.

2， to determine a good car stickers to place. Slowly the side stick， aside lightly with tools to scrape， and propose the paper.

3， meet the door handle or rubbing strips according to the situation of the material cut and into the.

4， appropriate adjustments， the graphics general position is correct， forced repeated scrape water and bubble. Remove the transparent film.

5， in the doors and sewn with knife knife， inward packet paste.

6， don't let the car stickers and body have any separation or protuberance.

7， try to let the car sticker in the water dry， the conditions can be moderateheating and drying. According to the weather condition， one or two dayslater after the car wash.

The mind.

The car paint stickers seems to be very easy to work， but to put it straight and smooth but not so easy， especially with large pattern. If we take theback paste are up to paste the car now， first of all it's easy to get the fingerprint， secondly stickers may mutual adhesion， and difficult to control，and if the direction is wrong to pull sticker sticky words， probably because ofstickers too soft to stretch it. We should start from the angle of stickers，setting off a small part of the back post (use the first cut if necessary); and then carefully aligned position， partially exposed the sticker affixed to the vehicle. Then we can observe the position is correct， then no problem， and then put back put apart， then paste， until the finished paste.

Stickers principle is from the inside out patch， is the middle part affixed first，reoccupy finger pressed outwards， so that the bubble out. If from the outside to the inside affixed words， the bubble will not run away (at this timein order to beautiful appearance can use the knife cut the bubble part).Another method is first coated with soap and water in the shell， so thesticker doesn't stick dead in the car shell， can adjust the position， or thebubble from the middle squeezed to the edge removal. Soapy water will be in after a long dry， this process not to touch it， dry stick is very strong.