Feature:
2.4GHz Wireless 7.0 LCD monitor with remote control
380TV lines clear picture display
Built-in IR lights for night vision range
Weather-proof design for outdoor usage
4-channel available to avoid interference
Built-in microphone for audio monitoring
Min. 100m transmission distance without blocks
Channel scan and channel skip for multi-camera usage.
Operation Introduction
Open the packaging box, take out the receiver, adjust the support post behind the receiver to a proper position, and put the receiver unit stably. Then install the antenna correctly.
Power the machine unit: Connect the input terminal of the receiver power adapter to AC 110~220V, other terminal to DC IN socket of the receiver. Slip the power switch to ON position, then the red power LED lights, the receiver starts up.
Power on the camera: connect the camera power adapter with camera, and put it on the correct position. Note: metal shield will loss the signal.
Channel selection: press the channel selection key, and the LED display will show the number from 1 to 4, the number means the relevant channel. As select the correct frequency channel, the screen will display the relative signal from the camera, also can adjust the frequency channel by the remote control.
Cycle frequency initialization: press the channel selection key for 3 seconds, the LED will display the number from 1 to 4 in rurn, and every number will keep 5 seconds, it is fit for more cameras working in the same time. Also can initialize the function by the remote control.
Receive more clear video: Trying to adjust antenna direction can get more clear video.
Adjust voice volume and video brightness on the relative side knob.
Video and audio output: Connect the A/V cable to show the video and audio
Video and audio input: press the channel selection key for a while will turn off the wireless receiving function and the LED only displays a red dot, at this condition, can connect the A/V cable with A/V source for monitor using.
Earphone hole belong the side of the receiver is used for external earphone.
Basic specification for 7" TFT LCD
Transmission frequency:ISM 2.400MHz ~ 2.485MHz
Modulation Mode:FM
Antenna Type:Camera Omni; Receiver; Directional
transmission distance:Min. 100m transmission distance without blocks
Antenna Port:50ohm SMA
Receiving Sensitivity: -85dBm
Vided output level:1Vp-p@75ohm
Audio Output level:1Vp-p@600ohm
Operating Temperature:-10 ~ +50 / +14 ~ +122F
Storage Temperature:-20 ~ +60 / -4 ~ +140F
Operating Humidity:85%RH
Screen Size:7.0 inch
Power Supply:DC12V 1.5A
Dimensions (W*D*H):190*140*20mm
Weight:425g
Technical specification for wireless camera:
Model:802C
Image Sensor:1/3 OmniVision CMOS
TV System:PAL/NTSC
Validity Pixel:PAL: 628×582 NTSC: 510×492
Horizontal Definition:380Line
Scan Frequency:PAL/CCIR: 50Hz NTSC/EIA: 60Hz
Angular Field of View:45° (f=6mm)
Minimum Illumination:0Lux
Input Power:27dBm
Output Frequency:2.4GHz (2.414GHz 2.432GHz 2.450GHz 2.468GHz)
Frequency Control:Adapt to MPU and phase locked loop to control frequency exactly, which possesses high stability.
Transmitting Signal:Ideo & Audio
Open transmission Distance:100M
Infrared Distance:10 15M
Power:DC12V/500mA
Current:350mA
Power Consumption: 4W
Working Temperature:-10 +50
Size:68×52×105 mm
Weight:230g
Package List:
1 x Camera power adapters
1 x 7.0inch LCD Monitor
1 x Monitor Adapter
1 x A/V line
1 x Remote
1 x Manual









