This RAB Holder is large enough for a Raspberry Pi an Uno or Mega 2560 and a breadboard convenient for making projects.

This 830-tie/point breadboard includes an IC area of 630 points plus two 100-point distribution strips providing 4 power rails.

With male-to-male jumper wires in different colors

Comes with red green and yellow LEDs (two for each color) and six 1kΩ resistors.

Technical Details

Introduction

This RAB Holder Kit provides you all the necessary components for a simple experiment including a breadboard quite a lot of jumper wires an RAB holder six LEDs and six 1K current-limiting resistors thus you can start the experiment right away.

With this kit you can fix for Arduino board Raspberry Pi and breadboard on the RAB Holder free of careless short circuits on a metal desk or caused by some metal parts underneath. What’s more it also comes with 65pcs jumper wires with different length in various colors therefore you can just plug them into the control board and breadboard to build circuits no bothering about complicated soldering.

Specifications

Size: 200 x 135 mm (7.87 x 5.31 inch)

1 x RAB Holder

1 x 830-Point Breadboard

65 x Jumper Wire

6 x 1kΩ Resistor

6 x LED (2 red 2 yellow and 2 green)

Several Screws

?