Dry paste method:
1. The part you want to paste clean， dry;
2. Strip part or all of the backing paper， set a good position， the fixed upper end， the sticker affixed to the car body from top to bottom;
3. scraped back and forth with a plastic scraper or bank card， completely out of the air;
4. Finally quit transfer film， it's done.
Wet paste method:
1. I want to paste the site clean;
2. Strip completely backing paper， sprayed with an aqueous solution of detergent in the rubber surface of the vehicle body paste parts and stickers;
3. To be a good location， the sticker affixed to the body carefully with a plastic scraper or bank card to the middle of the sticker around an appropriate force scraping， completely out of the water and air;
The natural air-dried for 30 minutes and finally thrown off the transfer film.
Car stickers clear
1 sparkling clear: After the adhesive is completed sometimes occur on the surface of the bubble sizes of stickers， foaming at the edges with a thin needle prick a few holes， then direct the air expelled by hand， do not try to hand directly to the blistering crushed.
Clear sticker: 1. Nail whipped corner and then the entire tear off without leaving any traces， not to hurt the primer.
2. When the cold weather can not be swept corner first with a hot air gun stickers proper heating， and then hand carefully removed from the body surface stickers!
3. For remaining on the surface of the body with alcohol to remove the residue!
