Package content: 1 x Backup Camera(phone and tablet not included) 1 x Host 1 x Drill 3 x Tie 1 x Instruction Introduction: This is the newest wireless parking camera system in the automotive industry, using smart system through WIFI point-to-point to parking the car Comparing with the current wired and 2.4G wireless parking system, this new parking system has the unparalleled advantage. It can widely used in cars, buses, container truck, MPV, lorry, shop truck, fire engines,team ship and so on Features: The device works with Apple Products and Android Phones( I o S 6.0 above and Android 4.0 above) Newest transmission and new combination of display Any IOS and Android device with WIFI can be used Free wiring, wireless reversing, easy to install, save the installation cost Use of WIFI transmission, widely used in various vehicles 10-20m transmission distance, If there is a blockage, will it affect signal strength The most advanced H.264 video encoding format, digital signal, high definition image quality Based on TCP transmission, digital signal without interference Low power consumption High-quality wireless car camera with aluminum housing high-definition CMOS, wide-angle vision, IP66 waterproof, for indoor and outdoor all-day work Specification: Transmission method: WIFI digital signal Video compress: H.264 Antenna spec: Omni-directional Transmission distance: 10-20m(Note: If there is a blockage, will it affect signal strength) Work temperature: 0℃~ +50℃/ +14 ~ +122F Store temperature: -20℃~ +60℃/ -4 ~ +140F Work humidity: 85%RH Sensitization chipset: CMOS Image pixel: Million pixels Visual angle: 120°~150° Minimum illumination: 2.0Lu/F1.2 Transmission rate: 80mW Power: DC 12V Night sight distance: 5-10M Waterproof level: IP66 Fix type: Drill-hole type Image receiver:Device with WIFI How to use the device? 1. Please scan the barcode on the package, downloand and install CarRMoniter to your Apple IOS and Android device 2. Turn on your Phones WIFI, search GLW-CAR-R signal and connect it, enter password How and Where to install backup camera? 1. Turn off the vehicle power supply. Do not power on when the camera haven‘t been installed well to prevent short-circuit damage to the device 2. Determine In-vehicle camera mounting position Socket Type: drill hole, remove the screws to open the lens cover from the rear of the lens aperture leads, and then fit on the screw and spring ring, push the lens to fix the camera firmly after adjust level of positive image. Install the power wire: R + connect to the reversing lamp power wire ( positive pole ), S + connect to the brake lamp power wire (positive pole), GND (-) connect to any metal of the vehicle, start the car, brakes, reverse gear, then the reversing image can shown on your phones device Note: Please follow the mark of the power wire (R +: reversing wire positive pole, S +: brake wire positive pole, GND: negative pole)