■在庫はない場合は、通常5～10日以内に発送。販売元直送の場合もあります、発送後に追跡番号を発行。 納品日数は最大10-15日の場合もあります。<br/>■初期不良・不良品による返品・交換(3日内)の返品送料はお客様負担となります。<br/>Geekcreit? 3D Printer Controller For RAMPS 1.4 Reprap Mendel Prusa Arduino<br/><br/><br/>Description:<br/><br/>Fully assembled & tested  no soldering required<br/>It is designed to fit the entire electronics needed for a RepRap in one small package for low cost<br/>The modular design includes plug in stepper drivers and extruder control electronics on an Arduino MEGA shield for easy service  part replacement  upgrade-ability and expansion<br/>A number of Arduino expansion boards can be added to the system as long as the main RAMPS board is kept to the top of the stack<br/>Size: Approx. 11.5 x 6 cm / 4.53 x 2.36 inch<br/><br/>Package included:<br/><br/>1 x 3D printer controller for RAMPS 1.4