Function Button:

TEMP (at the front housing):

a( To switch between C or F Selection

b( ln setting mode (as below point 4 & 5):to decrease the figure.

ADJ (at the front housing):

A( To switch between 12-hour or 24-hour format Selection.

b( ln setting mode (as below point 4 & 5):To increase the figure.

SET (at the front housing):For Time / Date / Week / Calendar Selection.

ALM ON/OFF(at the rear housing):For Alarm On / Off Selection

ALM SET (at the rear housing):To set alarm time

RESET: To re-set the unit to factory preset condition

Time & Date Setting:

Press the “SET” button for 2 seconds to enter the time /Date Setting Mode: When the hour digits flash press “ADJ” or “TEMP”button for hour-setting. Then press SET button again (minute digits will flash )  to  enter minute-setting

Then press SET button again (Year /Month /Date will flash)to enter date-setting.

Whenever in hour or minute or date setting, press the “TEMP” button to decrease the figure press the “ADJ” button to increase the figure.

Alarm Setting:

Press “ALM/SET”button for 2 seconds, a”BELL”sign which mean alarm on will display at the LCD the hour digit will flash Press “ADJ”of”TEMP”button for alarm hour setting. Then press “ALM/SET”button again for alarm minute setting.(note;Press the “TEMP”button to decrease the figure, press the “ADJ”button to increase the figure)

When complete the alarm setting press “ALM/SET”button again to back to normal display

Hour Selection:

Press the “ADJ”button to switch between 12- hour or 24-hour format

Temperature Selection (Celsius C or Fahrenheit F):

Press  the “TEMP”button to switch between C or F display selection

Alarm On/Off:

Press the “ALARM ON/OFF”button to switch on and off the alarm function.(note:the BELL sign at the LCD means alarm function is on Without the BELL sign means alarm function is off)

If alarm is on alarm sound will off automatically after 1 minute During the alarm sounds user could press any key to switch off the sound

When any setting-mode is being operated the unit will be back to normal display 1 minute after no key is being pressed.

RE-set the unit:

To re-set  the unit to factory pre - set condition press the “RESET”but