SkyRC TS50 ESC is a brushless sensored or sensorless ESC with small size, light weight, and electronic power switch, which is designed for 1/10 Buggy and Touring car. It accepts 4-6S NimH or 2S LiPo battery, and its BEC is 6V/2A<br><br>Features:<br>Less resistance, less heat, more effective.<br>Users could set the punch/brake control rate by point or custom the throttle/brake curve by themselves, and different customers&#39; request for linear and power all can be met.<br>A simple push button operates the switch meaning to eliminate the problems associated with intermittent contact of an ordinary mechanical switch.<br>The user could set and store 10 sets of profiles in the ESC. These data could be called out at any time without any special program setting. All the setting can be exported or imported so that the user could compare and analyze.<br>Safety features: low voltage protection, motor and ESC overheat protection and signal lost protection.<br>It also supports firmware update and can be programmed by program box, and SkyLink via PC.<br><br>Specifications:<br>Brand: SkyRC<br>Item size: 35.3 * 32 * 19.7mm (without cable)<br>Item weight: 60g<br>Power supply: 2S LiPo battery, 4S-6S NiMh battery<br>BEC output: 6V/2A<br>Constant current: 50A<br>Burst current: 300A<br>Resistance: 0.0006 Ohm<br><br>Safety Note:<br>It is not a toy and suitable for users older than 14years old.<br>Never allow water, moisture, oil or other foreign materials to get inside ESC, motor, or on the PC Boards. It may damage the ESC completely.<br>Never disassemble the ESC and modify the components on PC Boards.<br>Suggest using the original wires and connectors which are packed in the box.<br>Never solder one part for more than 5 seconds as some components will get damaged by high temperature.<br>Never run the ESC w/o load at full throttle and it may damage the bearings and other moving parts.<br>Please make sure the location where to fix the ESC has good airflow ventilating so that the heat could dissipate quickly.<br>To avoid short circuit, please keep the ESC connectors far awwayfrom other metal parts.<br>Never connect the battery in polarity in reverse.<br>Please remove the pinion gear before performing calibration and programming functions with the connectors (It is easy to get loose when running).What&#39;s more, make sure the cables not touch the moving parts.<br>Electronic motor timing will increase the temperatures of ESC and brushless motor. Use extreme caution when setting up and testing your application to avoid overloading and overheating.<br>Incorrect Boost and Turbo timing setting may cause permanent damage to the ESC and motors. Please choose proper ratio and timing setting according to motor&#39;s instruction.<br>To avoid signal interference, plaese always turn on the transmitter first THEN turn on the speed control.Do the opposite when powering it off.<br>Never use faulty accessories,e.g. motor which may damage the ESC. Always insulate exposed wiring with heat shrink tubing or electrical tape to prevent short circuits, which can damage ESC too.<br>Always disconnect the battery pack from the speed control when not in use to avoid short circuits and possible fire hazard. When the ESC is switched off, there is still small current and it may cause over discharge of the battery after some time.<br>The ESC can support 4-6 cells NiNH or 2S cells LiPo battery.<br><br>Package Information:<br>Package size: 12.3 * 8 * 5cm / 4.9 * 3.2 * 2in<br>Package weight: 95g / 3.3oz<br>Brand gift box package<br><br>Package List:<br>1 * SkyRC TS50 50A Brushless Sensored Sensorless ESC<br>1 * English Manual