Product introduction:

Name: General LED mirror lamp, rearview mirror anti-collision glue

Voltage: DC－12V

Color: blue, yellow

Size: 16.5X2.5cm

Weight: 6.64

Product features:

1 the use of flexible circuit board and the back of the 3M glue, can be installed on the curve surface mirror, according to the installation requiresproper bending;

2 then turn lights or lights use;

3 high temperature resistant, waterproof material, durable;

4 the use of ultra-thin, ultra bright LED;

5 environmental protection, low power consumption, high brightness,easy installation, a variety of models of general;

Installation instructions:

Method: (a) must be removed in the mirror

1 please bend the same radian with mirror.

2 then forced up.

3 remove the tripod in the car.

4 loose screws, remove the mirror.

5 put the wires from the round tripod put into the car.

6 using double-sided adhesive tape fixed wiring in the mirror below, make it not easy to see the wire.

7 pull the wire to engine room, connected with the lights on.

8 perfect installation.

Methods (two): not to remove the mirror

1 please bend the same radian with mirror.

2 then forced up.

3 using double-sided adhesive tape fixed wiring in the mirror below, make it not easy to see the wire.

The 4 wires along the mirror affixed to the door edge.

5 pull the wire to engine room, connected with the lights on.

6 perfect installation.

7 can still be seen from the rear lights.

8 perfect installation.

Have a look the picture below, flexibility that is quite good, the back isstrong double-sided adhesive, absolutely firm!