This product requires connection and use electric drill hole， if the circuit does not know dearestions to repair factory installed!

Product introduction: This product is a new green light source for a vehicle， has passed RDW E4 certification standards. The lamp has no pollution， no noise， no electronicinterference， as a result of the constant flow control technology of Germany advanced，uniform light color， plump， lasting constant.

A set of the box with a lamp two to send a set of special drill

Recommended a purchase two sets of this four door has!

Product parameters:

Working voltage: 12V~24V

Rate of industrial output: 3W

Working temperature: -40 ℃ ~105 ℃

Lamp size: length 8.4CM， diameter 2.8CM

Product features: the automobile decorative lighting， provide the pleasing light vision.

 

Installation steps:

1 remove the door cover;

2 screw drill in the door cover bottom drill a hole;

The 3 lamp fixed on the door cover;

4 a connection， if the original car Yingbin lamp (that is， the door opened the door on the)directly and it parallel to take power， if the car interior trim panel did not welcome lampwould need wiring Oh， general connection mode is positive in the interior ceiling， the doorswitch from the negative， if already installed Yingbin pedal only and Yingbin pedal powercan be connected in parallel

5 the door cover;

6 installed.