1 x Octopus Tilt Sensor Brick 1 x Analog Sensor Cable (15cm)
Octopus Electronic Bricks、 you can use them build electronics projects just as easy as piling bricks. By using Octopus electronic bricks、 you may connect Arduino / Freaduino compatible boards easily with various digital、 analog and I2C/Uart interfaces. These the breadboard-less firm connection are prepared to extensive modules like poteniometers、 sensors、 relays、 servos、 even buttons、 just plug and play.
Octopus Tilt Sensor is a sensor based on tilt switch、used together with Arduino specific sensor shield for the measurement of object angle. Three pins electronic building blocks interface: input 5V - GND. S for the detection pin.
- Operating voltage:DC 5.0V
- Power supply needs: 5V
- Interface type: Analog
- Pin Definition: 1-Signal 2-VCC 3-GND
- Fast response and High sensitivity
- Simple drive circuit
- Stable and long life
Dimensions: 1.38 in x 0.79 in x 0.20 in (3.5 cm x 2.0 cm x 0.5 cm) Weight: 0.21 oz (6 g)