Acer acer Iconia A1-830 screen film

Dedicated film, without cutting
Protective film step analysis:

The first step: clean the screen

Wipe the screen with a cloth (or soft cloth or glasses cloth) to clean the screen completely. Wipe the screen is best indoors without wind, clean environment to reduce the impact of dust on the film.

Because the film before the thorough cleaning is a must, such as accidentally stained with dust will have a direct impact on the film results, ranging from bubbles after the foil, leading to failure of foil. Many of the poor quality of the protective film is because the process can not be cleaned into the dust film directly destroy the protective film of the silicone layer, making the foil scrapped can not be used.

The second step: get the initial impression of foil

Take the protective film out of the package. Do not tear off the release film. Put it directly on the screen of the mobile phone for the initial film impression. Especially observe the fit of the film edge and the screen of the mobile phone. The understanding, which will help behind the foil program.

The third step: the No. 1 tear film part of the film

Observe the label on the protective film, tear off the release film labeled "①", and be careful not to touch the adsorption layer of the protective film with your finger. Each protective film products are divided into three layers, of which ① and ② are release film, the role is to protect the middle of the protective film.

Step four: slowly paste the protective film to the phone screen

Align the protective layer's adsorption layer with the corners of the screen, making sure you position it and then carefully attaching it. While the paste, while tearing ① No. release film, if the film bubble process, pull back the film, re-affixed. Confirm the film position is completely correct, and then completely tear ① number release film.

The whole piece of protective film are affixed to the screen later, if you still find bubbles, you can use the scratch card (or ID card.) About scratch the screen, the air is discharged.

The fifth step: the No. 2 release film completely torn, foil finish!

Foil points:

1, before the film should be thoroughly clean the screen, in particular, can not leave dust.

2, ① No. tear film from the release film, with special attention to the fingers can not touch the adsorption layer, or affect the film effect.

3, the film process, do not take the number of release film ripped apart, should be torn, while the paste.