1pcs for Arduino Sensor Shield V5.0 Expansion Development Board DIY Blocks Of Robot Part

We can build electronics projects just as easy as piling bricks. and community have made the programming much easier than ever before. How about some elixir on hardware part Maybe it is not yet convenient to make complex interfaces but we can at least start from the most commonly used modules.

By using electronic bricks you may connect compatible boards easily with various digital analog and I2C/Uart interfaces. These the breadboard-less firm connection are prepared to extensive modules like poteniometers sensors relays servos...even buttons just plug and play.

Each terminal module has buckled port with VCC GND and Output which has corresponding port on the sensing board with a plain 2.54mm dual-female cable you may start playing already. Buckled brick cables are like cement for bricks make the connections easier secure and more professional looking.

You can easily connect with usual analog sensors by using this expansion board such as ray sensor.If you support by this expansion board and corresponding circuit module you only need to combine and sensors module by using special cables because concrete circuit details achieve by corresponding sensors module so you only need to consider that how to read data coming from the sensor by program in .

Emartee Sensor Shield V5.0 pinout all of the digital and analog interface;
Support IIC interface
Support 32 road Servo Motor Drive Shield interface
Support bluetooth module communication interface
Support SD card module communication interface
Support APC220 wireless rf modules communication interface
Support RB URF ultrasonic sensors interface
Support LCD serial and parallel interface

1pcs for Arduino Sensor Shield V5.0 Expansion Development Board

Packaging Details
Unit Type: piece
Package Weight: 0.100kg (0.22lb.)
Package Size: 10cm x 10cm x 5cm (3.94in x 3.94in x 1.97in)