Technology:
Materials:
Basic technical parameters:
The finished assembled standard amplifier description:
1. Tube amp must connected with speakers before turning ON. Strictly prohibit send signals to amp without connected loads(speakers) or load short circuit when the switch is ON.
2. Too high or too low power supply voltage does irreversible harm to the amp,preferably less than 5% of the specified voltage. If your mains voltage exceeds this value, often best to use with the AC power supply.
3. Temperature is higher when tube amps working, placing attention to ventilation, cooling.
4. In the boot or just shut down for a period of time (within 30 minutes) Do not spill liquid on the tubes.
5. You should take about 100h time to operate the amp.RUN-IN to the amp gives it's best and stable sound.so during the first 100h use time the sound maybe is not the best,you can also use your own run-in method.
All tube amplifier used with stereo mode: 2 speakers, L and R.
Normally there are 6 RCA outputs are for 2 different impedence which are 4 ohms or 8 ohms than: +8L, +4L, -0L, -0R, +4R, +8R
Example when your speakers are 8 ohms, you plug +8L and -0L for left speaker, -0R and +8R for right .
And for 6 ohms impedence speakers you can plug to either 8 ohms mode or 4 ohms mode.
Some tube amplifier power cable(plug) is not included, because of the electrical outlet format, but you can always use the PC power cable(plug) in 110v- 240v
Our Tube amplifier guarantee :
Tube amplifier Guarantee: 3 months for tubes, 12 months for the machine. Some tubes' guarantee extended to 6 months or 1 year(indicated in the product description)