Have a cracked/broken screen on your iPhone 6S? This is the part you are looking for!
This display assembly will only work in an iPhone 6S! It will not work in an iPhone 6.
This part includes the For iPhone 6S Home Button and Ribbon Cable attached to it, which means you don''t need to transfer them from your old screen onto this new one.
You want to replace it by yourself? No problem, all the required tools are included in the package.
Quality Guarantee: All screens are fully tested prior to shipping

Technical Details

Product Details

Package Dimensions
Width : 4.02 inch
Height : 0.98 inch
Length : 8.31 inch

Shipping Weight: 1.12 pounds (View shipping rates and policies)

ASIN : B06XRSQWNK

Product Description

Note:
*This part does include the home button, front facing camera, earpiece speaker, and the LCD shield plate.

*You will not need to transfer these parts from your old display assembly to your new part.
*Touch ID Not Availabie this homebutton does not have the touch ID/Fingerprint identification function.you will need to
transfer the home button from you original screen onto this display assembly to retain this functon
*When removing the screen, it is highly recommended to use a blow dryer to heat the edges which helps to separate the screen from the seal.

Fix Kit Contents:
1 * LCD Screen
1 * 8 in one Iphone Boot tool
1 * Nano Protective Film

Compatibility:
*All iPhone 6S (Not iPhone 6)
Instruction:

*Please search ''Replace iPhone 6s Screen'' on YouTube for a video instruction of how to do the replacement.

Issue:
white lines/spots on my screen,the screen is totally white or black.Solution :It is always caused by the FPC connection, please check the connection is in good condition and
use some alcohol cotton to clean the interface of FPC, then try to reconnect it.
Issue:
The FPC cable is short Solution :Please make sure the FPC stretch out the little hole fully and not flexed. Issue: The screen is flashing.
Solution:
Please do not install the screen with the back light on. You are strongly advised to turn off the iPhone before installing.
If the screen flashes, please take it off and put it aside for 24 hours then reinstall the screen to your iPhone. Issue: Ribbon connector not working.
Solution:
Clean the ribbon connector with alcohol and try to test it again from another motherboard.
Touch ID is not available in this product. Home button does not have the touch ID/Fingerprint identification function.
Transfer the home button from your original screen onto this display assembly to retain the function.