3M™ Door Edge Protection Film is a super tough 6-millimeter thick clear coated urethane film that helps preserve your vehicle's finish. It is made from the same material as the professionally-installed car door protectors used at car dealerships and safeguards the edge of doors from abrasion, door dings, chips, environmental corrosion and other minor damage. It is an easy-to-apply film requires no tools for installation. Once applied, it requires no special care. A small investment that can make a big difference in keeping your car looking new!
Contains two 91.44cm (36 inch) Door Edge Protection Film strip on a single sheet
Protects door edges from chips, scratches and scuffs
Helps keep appearance looking new
Cleanly removes if needed
Easy to apply, no tools required
Virtually invisible and clear coated to help make it resistant to yellowing and staining
Ideal for most sedans.
1.Wash your hands thoroughly. Avoid application in windy conditions as dust or other debris may attach to adhesive.
2.Clean the door edge pn both the interior and exterior surfaces using 3M™ Car Wash Soap, rinse with water and dry with a microfiber towel.
3.Start to remove one strip from the paper. Do not pull the entire strip off the paper as the adhesive can become contaminated.
4.Beginning at the top, press the film onto the door's exterior surface so that half of the film width is on the outside door edge, and half is extending beyond the door edge.
5.Continue this process down the door edge to the bottom of the film. Trim at the bottom as necessary with scissors or razor blade. Note: Use caution with cutting tools, as sharp blades can cause serious injury or harm paint. Follow manufacturer's instructions for each cutting tool used.
6.Begin pressing the film around the edge of the door over the entire length of the door, but not all the way to the back side yet.This will help to prevent air bubbles.
7.After starting to secure the edge, continue to fold the film around the back of the door edge over the entire length of the door.
8. Remove all air bubbles by smoothing with moderate finger pressure.
