Specifications:
<br />Frequency range : 950-2150MHz
<br />Supply voltage : 13-18V DC
<br />Input level range : -40dBm~ -10dBm
<br />Operating temperature : 0-40
<br />Impedance : 75¦¸
<br />Use LCD to display the satellite signal intensity
<br />Built-in signal alert buzzer
<br />With LCD backlight / buzzer and attenuation control function
<br />DC pass to LNB
<br />
<br />Package Includes:
<br />1X SF-95DR Digital satellite finder
<br />1X 21cm coax cable
<br />1X User Manul 
<br />
<br />SF-95DR has a blue back light to allow use at night. The signal meter never needs to be recalibrated nor does it need complicated programming.
<br />It automatically recognizes the LNBF frequency and works with any C band, Ku band, or Ka band satellite.
<br />
<br />No need to input transponder frequency, symbol rate, or polarity. Truly plug &amp; play.
<br />
<br />ATT increasing key. If the incoming signal is too strong, (the thermometer-scales shows max and the signal strength value shows 99) it can easily be attenuated by enabling this &quot;attenuation&quot; funtion, it reduces the incoming signal to a lower level. There are four step attenuation totally.
<br />
<br />How to connect :
<br />connect a jumper cable from the LNB to the &quot;Satellite&quot; port on the digital SATFINDER.
<br />connect the cable from your satellite receiver to the &quot;Receiver&quot; port on the digital SATFINDER.
<br />
<br />Note:
<br />To avoid a continuous full scale reading, do not use the digital SATFINDER directly in front of the dish.
<br />When using a LNB with gain higher than 60dB, insert a 5dB attenuator between the LNB/LNBF and the digital SATFINDER.
<br />In case no satellite receiver is at hand a 13-18V DC power supply with F-connector can be connected on the &quot;Receiver&quot; side of the digital SATFINDER to power the SATFINDER.