Power: 1000W
Work: Split
Rated voltage: 220V
Use and precautions:
1. initial use， flame or smoke may occur after this is a normal phenomenon， power 5 minutes will automatically disappear.
2. The plastic sheet is heated to 130-140 degrees becomes soft state， a little pressure to the molding soldering temperature is generally about 240 degrees away from the solder nozzle orifice at a temperature of about 200 to 260 degrees 5-10MM; welding should pay attention to the distance between the nozzle and the solder joints. to achieve the desired welding temperature.
3. The heating wire off， shot shell rotatable connecting screws， remove the gun batteries， with the same specifications of the gun the core can be replaced.
The gun used up to light， so as not to break the core portion gun refractory ceramic material， leaving the electric wire shorted.