The left after the installation of the physical map:

 

 

After the installation of the real right:

 

 

Left with real:

 

The right to install in kind:

 

The old and new Epica real after installation:

 

 

The Chevrolet car three car mounted in kind:

 

 

 

 

"Brand" wing

"Color" black only (some photos look like grey， it is because of the camera light)

"Size" left: 60x17x22cm (length and width and height) on the right:60x17x22cm (length and width and height) (because the shape is irregular，is only about the size， the specific kind prevail)

"The weight of 2.3 kg (a pair of).

"Materials" standard 600D Oxford cloth + PE environment protection board(Note: not the board but PE plate， can be washed. PE plate thickness up to 2.8mm， so a pair of packets will have such weight)

Some models is symmetric， that how to distinguish between left and right?

As shown below， the installation time trademark toward the front place(Note: install the sample does not map the link corresponding baby physical map， for reference only)

 

 

 Your car if the pad 3D trunk mat， mat flanging is thin enough， you do not need to do any treatment， directly installed storage bag can be， but if yourmat is thicker， as I have shown below thick flanging mat， please follow the instructions below:

 

1 received the storage package found as shown below position two outerpanel angle， note that the two can be folded away in the corner inside the bag.

 

2 hand back and forth several times， until the angle taken down so far， apackage of two angle， a pack of four angle， as shown below， the angleposition has been slotted， and multi fold a few will be able to take down， no tools are required.

 

70% off off the outer side plate of the two corners， Oxford cloth folded inwardalong the angle， and then put the bag on the corresponding position rightafter installation， as shown below.