With Host: When driving long light will turn lights with synchronous flashing lights on the steering

Ordinary paragraph: while driving is not lit, the synchronization with the turn signal blinking lights on the steering

  Domestic wick

Cool side turn lamp

Ⅰ Parameter Description

Model: R100

Size: 12.5㎝ × × 1.7㎝ 5.0㎝

Weight: 180g / set

Shipping Packaging: 2 / set

Packing: Blister + color card

Package Size: 23.5㎝ × × 3.0㎝ 19.5㎝

Ⅱ Features

1. The new spacecraft design, fashionable;

2. The overall chromium plating process, easy to scratch fade, more distinguished luxury Xuanliang silver;

3.46 brightly lit LED lights embedded in the sci-fi feel quite spaceship command positions;

4. both night lights and turn signal functions, to ensure road safety;

5. Suitable for most vehicle installation, the original car with or without a small night light can be installed.

Ⅲ Installation Guide

Prepare well before the start of the following tools:

Red turn signals

Strippers

Word / Phillips screwdriver

Insulating tape

Note: The following text and pictures only describes the installation process for this series of products, the actual products to "Parameter Description" shall prevail!

Unless otherwise specified, the power required to meet all of the Company are used in electrical products 12V DC

Note: The "spaceship" shape of the turn signal has two modes, namely steady mode (night light) and a flashing mode (turn signal).

This article describes the installation location in the body side panel of the leaves. Line connection according to the instructions, you can both steady and steering indicator, that is, when the night light will light turned dark blade turning, turning when hit, the corresponding side will blink

Installation steps:

1. First, determine the position to be filled, we have chosen the board on both sides of the leaves, remove the original car steering light and clean body the appropriate location.

2. Since the turn signal lights installed control box with holes larger than the original car steering, if you want to directly control box stuffed inside the car from the outside is not enough. You need to cut the wires, control box into the engine compartment where the first line from the inside out stuffed and re-connected with the turn signals. It is noteworthy that some models of the mounting hole is large enough, there is no need to draw a line on the cut line, directly into the engine compartment on the line.

olor these two lines are close, do not reverse it!

3. This is the control box it! Nightlight is it to convert from the steady mode and turn lights flashing mode

  This is the turn signal lamp line, press the line connected to the installation instructions. Each drive signal line may be different colors, please note the distinction

5. Wiring

6. Connect the line after power test. Engineers get one, the test is successful! We used three colors of products

7. Now start pasting stickers before clean install location. Remove the adhesive

8. affixed to the body, pay attention to proper wiring, it is best not see the wire after a good fit......