Product Name: were the source of the engine start / emergency 600A battery line cell line12V vehicle

Brand: were the source of

Specifications.

Standard Edition: length: 2.5 meters width: 15 mm net weight: 2.1kg (default)

Extended Edition: length: 3.5 meters width: 15 mm net weight: 2.8kg

The price of 3.5 meters long version is 83 yuan, the longer version of the client, pleasecontact customer service, the difference of 25 yuan.

Explain.

When your car because don't worry no power could not beat the car from the side of the road, hit a taxi at a clip easily. Very few cars had no electricity, but once in a while have no electricity, really annoying. Not afraid of ten thousand, just in case, or take a battery clip will be good. Without any menace from the "rear".

[step]

A red clip head 1, link cable (+) to post positive dead battery.

Another red clip head 2, connecting cable (+) to the terminal of the battery cathode.

A black clip head 3, connecting cable (-) to the negative terminal of the battery.

4, the cable is another black clip head and the engine casing or the automobile body is connected.

5, start, please instantaneous operation, have a 10 second cooldown between adjacenttwo start.

6, unloading cable steps in reverse installation procedures.

[note]

1, in strict accordance with the operation steps.

2, check the battery voltage of two mark, to ensure that the voltage two battery of the same.

3, shut off the car all load, neutral position, pull the hand brake, start the engine. Smoking is forbidden in the vicinity of the vehicle.

4, if the car battery has been frozen, prohibit, or it may cause an explosion.

5, make sure that the battery terminal correct polarity.

6, during the operation, vehicles can not contact with other vehicles.

7, the battery will produce explosive gas! Install the cable when you wear protectivegoggles.

8, if the acid storage battery in the inadvertent leakage, splash the skin or eyes, rinse immediately with plenty of water, and then ask a doctor for help.

Connecting procedures are as follows: (1) the start line of the red wire clamp on "red cell anode was saved.". (2) and then the other side of the red wire clamp red cell anode in the "rescue" car. (3) the black wire clamp on the "black car battery is saved". (4) and then the black wire clamp in the "rescue vehicle" black negative battery. (5) to start the engine of the "rescue vehicle", and then start the "rescued" car engine. If it is found that the rescued the car still can not start, check the metal contact parts is bad. When completed to start the engine, still need to be removed in order to start a fire, or they may cause a short circuit.

Remove line procedures are as follows: (1) the "rescued car" black wire removed. (2) the"black wire rescue vehicle" removing. (3) and "the red wire rescue vehicle" removing. (4)the "red wire rescued car" removing.