Environmental soft strip， product width: 7 mm， height: 10 mm
[Baby Color: white， blue， red， green
Length: 24CM 48CM 72CM 96CM 120CM
Installation site: installed in the car chassis
Installation:
The car is placed on a table or on a suitable location lift trench around the vehicle chassis so.
Features:
1. power， only low power consumption， suitable for any 12V car power.
2. Long service life
3. Fully sealed waterproof design， 100% waterproof.
4. Light can be any combination of longer length.
6. Easy to install， can be installed in the car or vehicle.
Installation:
The car is placed on a table or on a suitable location lift trench around before and after the car chassis
Cleaned parts to be installed， the light bar and paste parts to be installed in，
The four positive and positive light bar， anode and the negative power line (power line a different color difference) in parallel
Merged into positive and negative two power cords， by car into the front end of the chassis from the bottom of the engine. Plug the power cord before connecting the positive and negative power of positive and negative small car lights at night to achieve control by a small lamp switch chassis lights.
Connect the power cord or battery， a power cord into the cab to install a separate small control switch， and then return the battery separate line control.
If you need to cut， you must cut a multiple of 3， that is， only cut three lamp beads， lamp beads 6， 9 lamp beads，，，，，，; like scissors over later still waterproof.