=============== AIRCUBE MANUAL ================


Before installing the Router, please make sure your broadband service provided by your ISP is
available. If there is any problem, please contact with your ISP. To connect the Router, please
follow the steps below:
1. Power off your PC, Cable/DSL Modem, and the Router.
2. Locate an optimum location for the Router. The best place is usually at the center of your
wireless network. The place must accord with the Installation Environment Requirements.
3. Plug the power plug in the electrical wall socket. The Router will start to work automatically.
After finishing the steps above, please choose the operation mode you need and carry out the
corresponding steps. There are five operation modes supported by this router: AP, Router,
Repeater, Bridge and Client.

====2.3.1 AP Mode
As the supplement of wired LAN,aircube enables the wired LAN to connect to the Internet
wirelessly.
The default mode of aircube is AP. Plug the power plug of aircube in electrical wall
socket and connect the Ethernet cable correctly, you can surf the Internet by connecting your
PC(s) to the Router wirelessly.
On this mode, the only wired port works as LAN. Computer could connect to the device by either
wired or wireless way. The Pre-encryption function is opened by default and the default password
is the last unique eight numbers of each Router’s MAC address. To avoid the conflict of DHCP
service with front-end devices, the DHCP server is default to be closed on this mode. If you want
to login in the management page, please set your computer’s IP address manually.
1. Connect the LAN port of aircube to the wired network port with an Ethernet cable.
2. Plug the power plug of aircube in electrical wall socket.
3. Power on the PC(s) and notebook(s).
====2.3.2 Router Mode
As a wireless router, aircube enables multi-user to share Internet via DSL/Cable Modem.
On this mode, the only wired port works as WAN, which can be connected to DSL Modem with an
Ethernet cable. Computers could connect to the device by only wireless way. DHCP server is
default opened and it is recommended that the IP address and DNS server address obtained
automatically.
1. Connect the WAN port of aircube to the LAN Port on the DSL/Cable Modem.
2. Connect the WAN port on the DSL/Cable Modem to the wired Internet.
3. Plug the power plug of aircube in electrical wall socket.
4. Power on the DSL/Cable Modem, PC(s) and notebook(s).
====2.3.3 Repeater Mode
aircube is used to extend the range of wireless signal of the existing AP or wireless router.
On this mode, the only wired port works as LAN. Computer could connect to the device by either
wired or wireless way. The SSID of aircube should be the same as that of the device you
repeat. To avoid the conflict of DHCP service with front-end devices, the DHCP server is default to
be closed on this mode. If you want to log in the management page, please set your computer’s IP
address manually.
1. Plug the power plug of aircube in electrical wall socket.
2. Power on the notebook(s).
Note:
It is recommended that you connect a PC/notebook to the LAN port of the Router with an Ethernet
cable, and then login the Router from the PC/notebook to set the Router in AP Repeater mode.