On/Off control via Z-Wave, manual wall switch and/or built-in button
Optimized antenna range
Fits in most gang boxes worldwide
Turns an existing wall switch into a Z-Wave switch
NOTE: Please read the product description to know specific instructions

Technical Details

Product Details

Product Dimensions

Package Dimensions
Width : 3.4 inch
Height : 1.4 inch
Length : 5.2 inch

Item Weight: 0 ounce (View shipping rates and policies)
Shipping Weight: 3.2 ounce (View shipping rates and policies)

ASIN : B008VWBNAU

Product Description

Your existing in-wall switches can be easily turned into Z-Wave switches with the Aeon Labs Z-Wave Micro In-Wall Appliance Switch. The wireless module is powered from the mains supply. Its three-wire design requires a neutral connection. In the event of power failure, non-volatile memory retains all programmed information relating to the units operating status. The wireless protocol is based on Z-Wave, which provides a mesh network for commands to hop reliably from node to node. FEATURES: On/Off control via Z-Wave, manual wall switch and/or built-in button. Fits in most gang boxes worldwide. Optimized antenna range.
- Please do not over tighten screw using improper size of screwdriver

- Make sure that there is enough space in switch gang box while putting microswitch with force

- swap any of the wires ( neutral, line, load ) which burn the miscroswitch

- Make sure that line voltage is not connected to low voltage terminal

- Do not try to connect wire AWG14 or 14 to low voltage terminals as it is not suitable to handle it