


自动防干烧功能型,不仅仅煮药,还可以煲靓汤
亲们再也不用担心药会煎糊,水会煎干了!
? 本店药壶有防爆裂功能,可以直接空壶通电测试,空烧不会爆裂。
















?
?
?
?
使用说明书(修订版)
1、测试
第一次使用时,请先往壶体内倒入清水,水位须高于壶体底部的发热体约0.5厘米,然后接通电源,如果有快慢档功能的型号请设置为快档,此时电药壶会自动加热至沸腾,直至水份被蒸发至低于发热体时,自动停止加热停跳保温同时鸣音提示(绿灯)状态。测试完毕,机器可以正常工作、
2接通电源注意
接通电源的操作,必须先将电线插入机器,再将电线的另一头插到插座上,请勿先插入插座再插机器,操作不当容易引起短路碰火烧焦电线。接通电源时请确保壶体里面放置水,并高于壶体内部发热体至少1CM。
3、两副药一起煲,一副药连继煲
如果有客户希望两幅药一起煲,煲成2碗,这种情况下需要通过手动控制断电,即当你看到约剩2碗水时手动断电,要剩3碗水,4碗水也是同理。
4、放多少药,放多少水,煮多长时间。
放多几碗水都没有问题,(机器会自动工作)。根据机器原理,水位必须高于发热体,并不超壶体高度的70%(防止水量过多而溢出)。一般家庭药材水份低于发热体时倒出刚好1碗水左右(视不同药渣的密度、稠度而有所差别)。一般大人的药草大概200-300克,放置的水份越多,煲药的时间会越长,煮出来的药很浓,效果很好哦。正常煲药的时间快档为1-2个小时,慢档为3-6个小时,通常情况下请使用快档煎制,机器会自动工作。特别需要慢熬的药物请使用慢档煎熬(通常情况下很少)。
5,药壶进入煎药之后,当煎到壶内水位低于发热体,发热体顶部面板温度上升到125°-130°时,药壶会自动由加热状态转到保温状态,此时保温灯亮起!表示煎药完毕,如不需保温可切断电源,倒出药液!一般煎煮一剂中药耗时约1-2个小时,主要是根据加水多少决定煎药时间长短!水少时间短,水多时间长!?
6、药壶处于保温状态,当壶内温度下降到低于70摄氏度,药壶会自动转到加热状态提高温度,反复循环,达到保温效果
7,保温状态不宜太长,一般不要超3-4个小时,避免汤药被药渣反吸和反复加热蒸发,导致最后剩下汤药过少
8.如果需连续煎多次原药,应等药壶温度下降到与自然温度差不多,或用冷水泡上2分钟,然后通电煎下一次药,
9、白色减水陶瓷圈的作用
白色减水陶瓷圈,它的作用在于减少剩余药汤的量,就是煲好后的药量。请在放水时就先将陶瓷圈放置于壶体底部,如果陶瓷圈不慎断开亦不会影响使用的。陶瓷圈的作用煎煮小儿药草填充体积,也可以用普通陶瓷汤勺代替。其作用原理就是占用了底部的空间,使剩余药汤因此减少。
10.以上方法均为煎煮中药,炖补品及汤料方法与煎药稍有不同,水位同样必需高于发热体1CM以上,
11、注意事项
请勿将壶体放置于水中清洗,会导致底部入水而损坏电路。
插入电线时请先将电线插入机器,电线的另一头再插入插座,勿先插入插座再插机器,容易导致电线短路碰火。空壶测试时的时间不可超一分钟。(有防爆裂功能不代表长时间空壶空烧不爆裂)
如果水份烧干机器依然工作,有可能机器发热体部分有药渣遮到,影响温控器工作,如果测试用清水(没有加药渣)情况依然存在,则机器的温控电路部分出现问题,请联系更换。配合定时器使用免专人看管!(请尽量使药渣不会盖到发热体顶部,而是放置在发热体的周围.
Operating Instructions (Revised)
1, the test
The first time, please first into the pot body of water, the water level should be higher than the bottom of the kettle body of about 0.5 cm, and then turn on the power, if the speed profile function model set to fast, The pot will automatically heated to boiling until the water is evaporated to below the heating element, automatically stop heating and beating while keeping warm tone (green) state. Test is completed, the machine can work properly,
2 Turn on the power
Do not insert the plug into the socket before plugging in the power cord, and then plug the other end of the wire into the socket. Do not insert the socket before inserting the machine. Improper operation may cause the short circuit to fire the wire. Ensure that the water inside the kettle body, and higher than the internal body heating body at least 1CM.
3, two drugs with the pot, a pot of medicine with the following
If there are customers want two pots of medicine together, burn into 2 bowls, in which case the need to manually control the power, that is, when you see about 2 bowls of water when the manual power to 3 bowls of water left, 4 bowls of water The same token.
4, put the number of drugs, put much water, cook for a long time.
Put more than a few bowls of water are no problem, (the machine will automatically work). According to the principle of the machine, the water level must be higher than the heating element, not more than 70% of the pot height (to prevent excessive water overflow). General family medicine water is lower than the heating body poured just about 1 bowl of water (depending on the density of dregs, consistency and vary). Generally about 200-300 grams of adult herbs, placed more water, the time will be longer pot, boil out the medicine is very strong, very good oh. Normal pot time is 1-2 hours, slow for 3-6 hours, under normal circumstances, please use fast file frying, the machine will automatically work. In particular, slow-burning drugs need to use the slow file suffering (usually very little).
5, medicine pot into the decoction, when the fry to the pot water level lower than the heating body, heating the top panel temperature rose to 125 ° -130 °, the medicine pot automatically from the heating state to the insulation state, this time the warm light From! Said the finished medicine, such as insulation can be cut off without power, pour liquid! General decocting a dose of traditional Chinese medicine time-consuming about 1-2 hours, mainly based on the number of decoction decocting time length! Water less time is short, the water more than a long time!
6, medicine pot in the insulation state, when the pot temperature dropped to less than 70 degrees Celsius, medicine pot will automatically go to the heating state to improve temperature, repeated cycles, to achieve the effect of insulation
7, insulation should not be too long, generally do not exceed 3-4 hours, to avoid the decoction by the dregs and repeated heating and evaporation, resulting in the last remaining drug is too small
8. If the need to repeatedly fry the original drug, should wait for the pot temperature drops to and natural temperature is almost, or with cold water on the bubble for 2 minutes, then power fry the next drug,
9, the role of white water ceramic ring
White water ceramic ring, its role is to reduce the amount of remaining soup, is the pot after a good dose. Please put the ceramic ring on the bottom of the pot, if the ceramic ring inadvertently disconnect will not affect the use. The role of the ceramic ring decoction pediatric herbal filling volume, you can also use ordinary ceramic spoon instead. The role of the principle is to take up the bottom of the space, so that the remaining drug soup so reduced.
10. The above methods are decocting traditional Chinese medicine, stew and soup ingredients and decoction method is slightly different, the same water level must be higher than the fever of 1CM or more,
11, attention to matters
Do not place the kettle in the water to clean, will lead to the bottom of the water and damage the circuit.
Insert the wire into the machine first, then plug the other end of the wire into the socket, do not insert the socket and then plug the machine, easily lead to short-circuit the wire to touch the fire. The test time of the empty pot can not exceed one minute. (With anti-burst function does not mean that a long time empty-pot burning does not burst)
If the machine is still working, it is possible that the machine heating part is covered with dregs, which will affect the work of the thermostat. If the test water (no dregs) is still present, the temperature control circuit part of the machine , Please contact the replacement. With the use of timer-free hand guard! (Please try to make the dregs will not cover the top of the heating element, but placed in the heat around the body.