Position adjustment is subtle

I watched it immediately, but it will float some corner without sticking perfectly depending on the position. The position adjustment was serious to ensure that all the corners were adsorbed properly. I peeled it about 5 times and it repeated. Selling? The fingerprint prevention of my finger seems to remain perfectly. It is disappointing because it stands outstanding. Since it is really the size that is perfect for the screen, if you stick it it will not hurt the main body and it is safe.

Perfect at present

Size is perfect for almost no margin. So the first positioning is severe (somewhere in the four corners will float when shifting even a little), but VivoactiveHR says that the screen is a bit somewhat dented from the edge so it will be a lot hard. Since it is a glass film, the texture is also good. As for the watch, the glass film exudes a luxurious appearance more apparently than the plastic film. Although durability is unknown, I think that there is no problem unless you hit it.

Just size

It is very snug on the screen. It is pretty familiar to paste the glass film with a smart phone but it is unusual that it is made exactly like this (Recently the display is curved, but although I thought it was a small sucker and it was Nandakora, thanks to that, it stuck very much It was easy, because the screen is a bit deeper, I feel that there is not any sense of incongruity to think that it is standard under the condition that the glass film is tightened.Touch sensitivity slightly drops.The original sensitivity is very good, so it gets normal If you are used to not being pasted, you may feel that it is hard to work unless you push it a little stronger.

Re-review using one month

I will re-review with a month. At the beginning of use, I was thinking that it was perfectly protected and protected, but before a week I got a gap on the upper side, you can see that an air layer is formed under the plate. A phenomenon called⁇ which disappears when pressed with a finger = raised up. As the days passed, it became a month, but the floating up to the place of about 5 mm from the top occurred. Suddenly, when I tried putting the surfactant, I thought it was chewy, when I tried putting a mild detergent in the kitchen a little on the floating edge,, I will slowly penetrate with jiwiwa! ️ And the rise was resolved, and it revived to a beautiful state just like when you first stuck it! It seems there is a rising edge of the end that everyone is reporting because it is self-satisfied now that he has not lived 60 years ago, but there were ways to solve it ⁉️ temporary effect As it may be, I will give back the review again when it becomes useless. Evaluation may be good in the present condition ⭐️, but we will change it to three.

The liquid crystal becomes dark

It's sort of a glass-like board. It was a level of a level that you should not imagine films or such things. It will be just as strong as that. The dimensions are perfect as well. On the other hand, the liquid crystal appears dark whether the transmittance is bad. Although it is a level that does not matter how long it is.

There are variations in quality?

One piece floated up and down. At first I thought that it was such a thing but when I pasted the second piece it was perfect so there may be individual differences. I think that it is very good if there is no variation in quality.