Instructions
1. When the slide switch slides down, start the sprayer to start replenishing water, and the light blue LED lights up. When the sliding plastic slides up, the contact switch is turned off and the spray head is turned off, and the light blue LED light goes out.
2. When using replenishment, spray directly on the skin, and the built-in storage liquid is on the instrument to keep the instrument upright.
3, the normal use of spray distance from the skin about 10CM, after the use of makeup from the skin around 15CM
4, skin test function, the first contact with the probe need to test the skin, short press the button, liquid crystal display screen display, wait 5 seconds to read the data, the data will be retained for 10 seconds, to be displayed before 0.00% can be tested again, the skin As a result of the test, the moisture content is 50%-100% and the oil content is 10%-30%. The skin is adequate and the oil content is appropriate. At the same time, the smiling face of the screen will be displayed. The moisture and oil content are not in the previous range. Explain that the lack of water, too much or too little oil, need water, and the screen will show crying face.
5, charging treasure function, long press the button (5 seconds) to open the charging treasure function, you can connect the phone to charge the phone, while the green LED lights up, any other function in the charging process can be used normally
6. Low voltage detection function: When the battery voltage is lower than 3.1V, it will automatically turn off other running functions. At the same time, the red LED light starts flashing. After flashing for 30 seconds, it will turn off and enter the standby mode. It needs to be inserted into the charger and it can be used again if it exceeds 3.3V.
