■在庫はない場合は、通常5～10日以内に発送。販売元直送の場合もあります、発送後に追跡番号を発行。納品日数は最大10-15日の場合もあります。
■初期不良・不良品による返品・交換(3日内)の返品送料はお客様負担となります。
Eachine 32bits F3 Brushed Flight Control Board Based On SP RACING F3 EVO For Micro FPV Frame

Eachine 32bits F3 Brushed Flight Control Board Based On SP RACING F3 EVO For Micro FPV Frame

Description:

Brand Name: Eachine
Item Name: F3_EVO_Brush Flight Control
Dimension: 22mm*32.5mm
Thickness: 1.2mm
Weight: 3g

Features:

1. F3_EVO_Brush is in the revision on the basis of? the F3 EVO SP RACING it is a 32bits brush flight controller based on SP RACING F3 EVO firmware.
2. The flight control support 1S (4.2V) and 2S (8.4V) power supply 2S power can bring flying experience more violence.
3. Independent design of the circuit structure comes with the pressure reduction technology whether it is 1S or 2S power input UART1/2 output 5V UART3 output 3.3V
4. Using STM32F303CCT6 + MPU6500 advanced hardware platform F3 guarantee more stable flight.
5. With a 6-ways large current NMOS transistors operating current of up to 10A or more. Each machine is equipped with freewheeling diodes.
6. Support for PPM SBUS DSM receiver input signal.
7. With battery voltage detection and buzzer interface.
8.In support of the world almost all hollow cup motor including 1020 coreless motor.Support 6 motor.

Notice:

Before applying power pay attention to the battery voltage selection.
The default shipping is 1S (4.2V); When using 2S first need to disconnect the short contacts 1S and then put the two pads on the 2S.
Prohibit shorted together the three pads at the same time.

Receiver configuration:

1. DSM receiver soldered directly to the DSM interface 3.3V GND RX3 in CF software configuration UART3 for Serial RX and change the Receiver mode to RX_SERIAL and then set up the receiver brand with Spektrum1024 or 2048.
2. SBUS receiver soldered on GND +5V RX2 Pin of UART2.SBUS signal in CF software configuration UART2 for Serial RX and change the Receiver mode to RX_SERIAL and then set up the receiver brand with SBUS.
2. PPM receiver soldered on GND +5V RX2 Pin of UART2.No need to open RX Serial just in the CF software to change the Receiver mode for RX_PPM.

Package included:

1 x Eachine F3_EVO_Brush Flight Control Board