It is good for price but has difficulty

Pads hitting the chest tend to shift due to the relationship of the bands, and depending on the type of dogs, they are shifted sideways from the back. However, considering the price is pretty good? Because the rattling noise of the locking part of the camera was conspicuously recorded, we locked the parts with woodworking bonds and removed the camera at the part of the screws. 170 degree wide angle system runs with distortion of the screen ... Of course I think that it depends on the breed type and personality.

From the price, it is satisfactory enough

About the clamp part In my case I felt that power is not needed as much as you are writing. Even with one hand it opened about 3 cm, I think that if you hold it with men in both hands, it will open up enough. It's pretty hard to remove quick release part. About goose neck part is about 3 cm longer than genuine parts, the joint part is also a little soft And if it is fixed to the thing that does not move about use, I think that there is no problem, but since the clamp part shifts unexpectedly, the use with a bicycle etc. I think that it is unsuitable.

Not suitable for small dogs

I tried to attach to Chihuahua once, but the image was also insanely broken because the original fixed size is too large to be fixed because it is too large (lol) It is unsuitable for small dogs, lawn dogs etc. I think that it is very good for medium-sized dogs ^ ^ After that, I was very hated (lol) For your reference ^ ^

Camera mount which is much cheaper than the original

GoPro Hero This is a camera accessory that mounts the camera on a bicycle or the like. With a strong grip force the clamping range corresponds to 0.6 cm ~ 5 cm diameter widely to fix the camera. You can also position it to the optimum shooting angle by moving gooseneck. Original is about 5,000 yen so it is very cheap. It seems that there is no problem in mounting strength, so it is how long it will last. This is not known unless it is used for a long time, but let's assume that it is cheap so much as well.

Tight enough

Since it is considerably cheaper compared to genuine, purchase in a trial mood. According to the impression used, the strength of the clip is said. The neck part does not wobble with a slight shake, but movement is smooth because it is smooth. The difficulty is that compatibility with genuine mounting hardware is bad. In that part where you pinch and remove it with thumb and index finger (part to be attached to genuine table), this part of this product is narrow and can not be firmly attached in this installation part. (I'm sorry that I do not understand the official name and it is difficult to understand)

Firm and secure

This item itself, it is much cheaper than the original one, so I was worried slightly, but it is solid and accurate and it is sturdy. The clamping part is also hard, and when you open it you need power but firmly pinched securely so there is no problem. Goose neck part also has some degree of hardness so there is no worry of shaking it. I think that it is a strong friend for those who do not want to put out 6,000 yen on mounts. By the way it is not a sample review.

The neck part is somewhat poor.

The neck portion is somewhat poor. Craphy PT - 308 shooting light LED It was purchased for photography by pinching it on a tripod with steady light light. The part to be pinched is strong. Because there is less movement, is it durability? What? is. Neck movement has restrictions. Even if it maintains a certain degree of bending, it will become fuzzy by the impact if it hits a bit or shakes. I think there are individual differences, but that is a shame.

It can be fixed firmly.

I also use screw type clamps, but when considering screw tightening at the time of removal, I thought it would be nice to buy one. If you do not use Gooseneck, it is stable with less vibration, but it is only possible to adjust the tilt depending on the angle to be pinched so it may be better to use a pivot arm etc. in between.