Usage:

A film tools: ruler ? scissors or a utility knife ? a wet towel ? hard card ( scraper ) .

2 with a ruler and a utility knife or scissors to paste the film planted into each position size ( best pen to write down on paper do not mistake size ) .

3 To film the place cleaned with a clean towel ? then wet the glass surface with a watering can ? you can put some detergent ( to be posted up after moving film ? not about sticky dead can not move ) .

4 . The matte film peeled off the backing paper ? stickers affixed in place to align the corners and smooth. Edge welt smooth with a wet towel to put down the glass and paste between the membrane ( inside ) air and moisture rub out ( if not all matte film is relatively large to remove the backing paper ? you can go to the bottom side welt paper ) .

5 After formation ? after the majority of the air and water together ? then scrape the blade on top ? the air bubbles ? scrape out the water the whole ? not too hard ? as long as the water can be scraped off completely and air can be.

6 After the dry water Please 12-24 hours ( time depends on the weather is sunny ?12 -24 out of the sun ) do not go cleaning ? moving . ~ ~ ~ ~ OK

Note : Some of my friends say do not be afraid to tear down the paste ? then ask you to place the sticker affixed to the glass with a ( 30-40 degrees ) or hot water heating with a hair dryer blowing hot in tear on OK? and fear have torn the glass there gum ( available hot water ? alcohol ? gasoline? kerosene ) the stuff a rub on clean ^ - ^ .

About Transport creases? bubbles : Because the baby is rolled sent ? there may be squeezed in the transport process ? visible air bubbles between the film and the backing