Features:

1 appearance. small volume. Easy to operate.

2 protein isolate, physical filtration in one.

3 rapid decomposition of toxic proteins in the water, and other impurities in the water filtration, and maintain good water quality.

4 quickly and efficiently increase the content of oxygen in the water, which will help water biological children.

5 pump water using a needle leaves, fine bubbles and abundant, the isolated protein outstanding results.

6 applies to the sea.

 

Steps:

1 Before using the product with water to clean, do not use any cleaning agents.

2 product hanging in a fish bowl rim, the bottom of the adjustment screw, keep the product equilibrium.

3 Remove the lids of garbage to one end of the pump head cabinets with water, the water level must be higher than the top of the pump head 50mm.

4 Press intake switch "CLOSE" direction of tightening, then connect the power, water pump began to work, the water level gradually increased until it bends the entire pipe is filled with water.

5 Press intake switch "OPEN" direction. Note that this procedure, a little spin entered the gas switch, increasing the intake air quantity, so that the pump needle brush run-time, the product to work.

6 Allow the skimmer to run for at least 24 hours. During which time a wet foam, should be cleaned. During and after the bubble will reduce and occasionally produce sludge-like foam.

 

Easy maintenance and troubleshooting:

1 on a regular basis (20-30 days) to clean the pump rotor and pump rotor bore the dirt, to prevent clogging of the rotor running.

2 regular cleaning carbon cotton filter plate (30 days). Face to prevent dirt clogging and reduce the filtering effect.

3 When the gas was found to reduce the time, rotate intake switch several times to remove salt dirt clogged air intake

 

Skimmer filter body section: 180 * 80 * 250mm

 

25mm thick can be hung on the glass

Maximum depth 300mm inlet

Power: 6.6W

Flow: 500L per hour

Weight: 1160g