材质: 3D立体贴
服务内容: 支持安装
贴膜类型: 车身贴
Material: 3D stickers
Service content: support installation
Type of film: body paste

材质: 3D立体贴
服务内容: 支持安装
贴膜类型: 车身贴
Material: 3D stickers
Service content: support installation
Type of film: body paste
材料:锌合金
规格:外星人约3.7*5.3cm

恶魔骷髅约3.4*5.0cm （详请见图片标示）
适用车型:全车系通用
车贴位置：车尾 后备箱 尾翼 车窗 叶子板 雨刷 油箱盖



安装方法：
1、最好用酒精清洁干净要贴的位置，擦干保持表面干燥，不要有水、油迹、灰尘，近期最好没有上过蜡。
2、贴的时候要根据车贴的大小，选择平坦的地方，然后把车标背面3M胶的底纸去掉，（贴的时候，最好用电吹风加热一下胶面，使其粘性更强），直接贴上，用手压紧就可以了。
注意事项：一旦贴上，尽量不要再移动，也不要马上用手拉的方法去试验粘贴的牢固性，这样容易把胶拉坏，粘上去后2天内不要洗车
Material: Zinc alloy
Specifications: Alien about 3.7 * 5.3cm

Demon skull about 3.4 * 5.0cm (please see picture mark)
Applicable models: the whole car is universal
Car Stick Location: Rear Trunk Tail Carrier Leaf Slot Hood Tank Cover



installation method:
1, it is best to use alcohol to clean the location to be posted, dry to keep the surface dry, do not have water, oil traces, dust, the best recently did not have wax.
2, when the paste according to the size of the car stickers, choose a flat place, and then the back of the car logo 3M glue at the end of paper, (paste the time, it is best to use a hair dryer to heat the plastic surface to make it more sticky) , Directly paste, hand pressed on it.
Note: Once the paste, try not to move, do not immediately pull the method to try to paste the firmness, so easy to pull the plastic bad, stick up after 2 days do not wash