Description :<br>RM092 AC Live Wire Finder Detector Metal Find Wall Scanner Tester Electrical Equipments<br>Features :<br>Find out the course trend of electrical wires in walls.Distinguish AC live wires from ground wires (detect when the distance between the two kind of wires are 5cm).Judge that if various electrical equipments are with electricity or if the socket of power supply has voltages.Search for disconnection position inside the cables and electric carpet.Connect one end of the faulty wires to the live wires， other wires (the cable) are connected to zero or ground; open the inductor and move along the wires， the trip point occurs when the indicator lamp stops blinking and the sound stops.When searching for disconnection inside the electric carpet， make one end of the wire connect to the live wires and the other end connect to the zero line.<br>Specification :<br>Product Name: AC Live Wire FinderObject of detection: 90-250V AC (50-60 Hz)Depth of detection: About 0-40mm (affected by humidity of the wall)Power supply: 2 x AAA batteries(Not included)Operation current: &amp;lt;20mAOperation temperature: 0-40 degreesOperation humidity: 30%-70%Storage environment: -20 to +60\u2103， &amp;lt;85%Dimensions: 120mm x 24mm x 15mm<br>Operation tips :1. When thee signal is weak or not steady， please change another place to detect.2. When the indicator lamp blinks everywhere during detection， it is possible that static electricity exists on the wall surface， so the wall is not suitable for detection.3. Please do not move against the wall or move bevel ways in case of affecting the precision of detection.4. When the electrical wires are laid out horizontally， please hold the tool in horizontal direction and detect up and down.5. AC live wires in metal pipes or metal covered wire， as well as metal walls or walls of high density all cannot be detected， but the live wires in plastic pipe can be detected.6. The tool can accurately detect the center of electrical wires (make the center as the basis)， but the width can only be detected in a range.7. If the indicator lamp darkles or goes out when using， please check or replace the battery.<br>Notice: Do not use the tool under the following conditions.1. The surface of the wall is covered with aluminum films and metallic materials.2. Concrete or brick wall.3. Situations that condensation is easy to form (condensation under the dry surface also cause incorrect detection).4. Wall and plate with moisture stream (places that are affected by water like bathroom and kitchen should be excluded).5. Situations that the glue water or paint is not dry.6. High temperature and high moisture places.7. Near strong electrical wave (e.g. broadcasting station and radio wave).<br>Detection for electrical wires.Place the tool slightly against the wall and switch on the power， the indicator lamp lights up (please keep pressing the power button during detection).Move the tool right and left slowly without rotati