PCI-e Express 1x to 4 Port 1x Switch Multiplier Splitter Hub Riser Card with USB 3.0 Cable

If you need more than one PCI-E x1 slot on the motherboard was not any so much・?it touches you can think about it.

It consists of two parts・?one main card・?interface installed via PCI-E X1 on the motherboard・?two equipment cards・?both of which are connected together via USB 3.0 cable.

The device card also uses the United States Pericom Pericom PI7C9X bridge chip・?for switching PCI-E・?PCI-E between.

But even USB 3.0・?but also the theoretical bandwidth 5Gbps (625MB / s)・?one Into four Then remove the loss would only 150MB / s・?/p>

and even PCI-E 1.x single-channel bandwidth also has 250MB / s・?So this stuff more than enough to give you the best slots・?/p>

there will not be enough bandwidth・?not only for the performance requirements of the place.

herefore・?the transferred PCI-E slot is the best version above 2.0・?the 3.0 version is better.

Several Divided PCI-E 1X slot all is gen2 mode・?even if gen1 previously ・景t can be ok