BENKS TF

Characteristic.

Wear: super wear-resistant surface hardening treatment of the highest 3.8-4H, effectively prevent screen scratches;

Ar: high transparency, clear;

The strong adsorption capacity: strong adsorption force than commonprotective film adsorption capacity is more efficient, more easy to paste;

Anti reflective, anti glare: in the sun than other protective film shows more clear, more convenient to use in the field and the scorching sun;

The only real AR film market, no rainbow lines, no glare, anti body radiationprotection of eyesight.

Applicable models: Sharp 9130c 7 piece suit

BENKS - Installation Tutorial

Clean the mirror

Before the installation steps: wipe the screen out special lens cloth (lens)

Please remove the lens cloth, gently wipe the screen (lens), be sure to clean the dust on the screen (lens), stains.

Note: the screen does not completely clean, may produce bubbles causeinstallation.

Before installation, step two: use filter membrane cleaning

Then rip the blue dust film, slowly affixed to the screen (lens) adsorbed on the smooth, then back and forth, until completely pasted around the screen,then the filter membrane tear (affixed to the bottom paper), can completelyclear the screen of imperceptible dander and dirt.

Tip: dust film after use, remember to the end of the paper, so it can once again clean the other mirror.

Warning: once the dust adsorption surface contamination too much dust,dander, which lost its dust removal function, not be used adsorption (avoidmore clear clean mirror dirty)

Install

Install screen protector, please confirm the lean close to the direction of

Before installation, please be sure to remove the screen protector, carefulalignment liquid crystal screen mobile phone, to lean close to the direction of confirmation, carry out the following steps.

Installation of the camera lens protector, please confirm the lean close tosize

Before installation, please be sure to remove the screen protector, carefulalignment liquid crystal screen mobile phone, to lean close to the direction of confirmation, carry out the following steps.

Step one: make sure need to paste the protective film location has beenthoroughly cleaned.

Step two: open the Benks AR film, release film about a centimeter, avoid finger touch protection sticking surface.

Step three: the electrostatic adsorption layer Benks AR film with quasiscreen aligned, and paste side will, from type membrane slowly

Pull out slowly, as far as possible, avoid bubbles. You can use a credit card or cleaning wipes help will bubble slowly out

Step four: when the Benks AR film completely adsorbed to the film planedown the number.

Step five: with attachments supporting paste directly attached to tear.

Retaining paste Korah bottom mounted directly.

Use the remove drawing sign lean close to small accessories skills!

Remove the drawing sign can be used to install the small accessories, such as camera etc..

By pulling swab stick small accessories, alignment of its position with thepayment, use drawing seal small accessories benefits

In order to avoid touching the protective film paste level finger, stick dust. In order to ensure more smooth and convenient attached!