V1.1 version is available now and the biggest improvement is the integrated Frsky Rx via SBUS protocol. It has a noticeable improvement when the drone turn around.The world''s first compatible OSD, FrSky Rx, Betaflight, born for acro F3 flight controller for the Micro Whoop or Blade Inductrix quadcopter.
Fully programmable through Betaflight, using the onboard USB port, tune all the parameters, PID''s, and rates to your perfect settings
Firmware version: Betaflight BETAFLIGHTF3. Built in Frsky D8 protocol native receiver (SBUS), compatible with almost ALL Frsky radios(e.g. Taranis X9D/X9D Plus/X7) or Frsky compatible transmitter module
The flight controller board comes pre-flashed with Betaflight firmware, and pre-soldered 55mm power cable pigtail with JST-PH 2.0 connector, AKA PowerWhoop connector.
The V1.1 Version could support also support DJT module. Original version not supported.

Technical Details

Product Details

Package Dimensions
Width : 2.05 inch
Height : 0.79 inch
Length : 2.13 inch

Shipping Weight: 0 ounce (View shipping rates and policies)

ASIN : B074GXKKZ7