Package Include: Receiver*1

BF-101 remote transmitter constitute with GZ6010 receiver for illustration

 Technical parameter

1.Voltage:~110V±10%           

2. Frequency:50HZ

3. Power: 330W                  

 

Wiring

Power supply input terminal: N (Neutral wire )——Blue  L(live wire)——Red

 Power supply output terminal: connect with motor: N(Motor common)—Blue 

L1—brown  L2—black

 

Receiver installation

Connect the receiver with the motor, and put through the power supply.

Notes:

1. Receiver should not be installed on metal surface; otherwise, receiving distance will be influenced seriously

2. Antenna should be as straight as possible and should far away from metal objects. Direct contact to metal objects is prohibited.

 

Programming

	1.  Eliminating original setting on the receiver: Cut off power supply and then put it on again, Press “Learn key” on the receiver continuously for more than 6 seconds, the receiver gives out continuous long-sound “Di,Di,Di...” at first. And then, it gives out quick short-sound “Di,Di,Di,…” When the sound is disappeared release the “Learn key”

Note: If the receiver has been programmed with the remote transmitter, please skip the step.

2.  Enter into wireless programming status: Keep the “Learn key” on the motor continuously pressed for 3 seconds. Release the “Learn key” when the receiver gives out continuous long-sound “Di,Di,Di

3.  Programming remote transmitter & receiver: Keep down the “CONFIRM” key on the transmitter, the receiver send out “DI,DI,DI”,  that mean the programming of remote transmitter & receiver has been finished.

 

Operation of wireless control system

The receiver and the remote transmitter are as a whole set when they leave the factory. If there is any damage; replacement or losing, please contact with the supplier.

Please replace the battery in time when the remote transmitter indicator does not shine or the remote-controlling distance evidently become shorter.

Please take out the battery if the remote transmitter will not be used for a long time.

Setting of motor reverse running direction

(The setting is only operating when the motor running direction is opposite to the required.)

Cut off power supply of receiver then power on, when motor is in “stop” state keep down ” LIMIT” key first then keep down “STOP” key on transmitter for more than 3 seconds, Release both keys when the motor gives out quick short sound “Di, Di, Di ”, at this moment, the running direction is opposite to the original.