Proton Waja/Wira/New Saga 

( Without Transponder Chip )

Remote Control Duplicator.

Do it yourself !

And duplicate your car key at any locksmith shop.

 Duplicate Instructions

1. Hold the two buttons on top together at the same time until the Red LED blinking then goes off ,now  release any one of the button and press the release button again 3 times for erase the memory then the RED LED should be blinking continuously .Now release the both buttons , once you press any one of the button the LED will be goes off. Mean the remote status is standby for duplicating,

2.Put the remote controller side by side and press one of the two buttons of original(old) transmitter and one of the two buttons of new transmitter,hold until new transmitter RED LED bulb blinking 3 times and continuously on.

3. Now release both buttons, the first button has been duplicated from the original transmitter to the new transmitter completely.

4.Repeat steps 2 & 3 to copy other buttons.

5.The frequency was pre-set at 315mhz for PROTON original remote controller ,immediately in use after successful duplicated.

6.If failure to duplicate the remote controller ,please repeat the step 1, 2 and 3.

The lowest price in the market !