
Ample input capacity and hands-on control in a compact console that can handle a wide range of applications.
FEATURES
Electronic Musician - Editors' Choice 2015 (Yamaha TF Series Digital Mixers)
SPECIFICATIONS
Outline
|
Fader Configuration |
24 + 1 (Master) |
|
|
Mixing Capacity |
Input Channels |
48 (40 mono + 2 stereo + 2 return) |
|
Aux Buses |
20 (8 mono + 6 stereo) |
|
|
Stereo Buses |
1 |
|
|
Sub Buses |
1 |
|
|
Input channel functions |
8 DCA Groups |
|
|
I/O |
Inputs |
24 mic/line (XLR/TRS combo) + 2 stereo line (RCA pin) |
|
Outputs |
16 (XLR) |
|
|
Expansion slots |
1 |
|
|
On-board processors |
DSP |
8 Effects + 10 GEQ |
|
USB |
34x34 USB Audio Interface, 2-track recording via USB Storage Device |
|
General specifications
|
Sampling frequency rate |
Internal |
48 kHz |
|
Signal delay |
Less than 2.6 ms, INPUT to OMNI OUT, Fs=48 kHz |
|
|
Fader |
100 mm motorized, Resolution = 10-bit, +10 dB to –138 dB, –∞ dB all faders |
|
|
Total harmonic distortion |
Less than 0.05% 20 Hz–20 kHz @+4 dBu into 600 , INPUT to OMNI OUT, Input Gain=Min. (Measured with a –18 dB/octave filter@80 kHz) |
|
|
Frequency response |
+0.5, –1.5 dB 20 Hz–20 kHz, refer to +4 dBu output @1kHz, INPUT to OMNI OUT |
|
|
Dynamic range |
110 dB typ., DA Converter, 107 dB typ., INPUT to OMNI OUT, Input Gain=Min. |
|
|
Hum & noise level |
Equivalent input noise |
–128 dBu typ., Input Gain=Max. (Measured with an A-Weight filter) |
|
Residual output noise |
–85 dBu, ST master off (Measured with an A-Weight filter) |
|
|
Crosstalk |
–100 dB (Measured with a –30 dB/octave filter@22 kHz), adjacent INPUT/OMNI OUT channels, Input Gain=Min. |
|
|
Power requirements |
100–240 V 50/60 Hz |
|
|
Power consumption |
110 W |
|
|
Dimensions |
W |
716 mm (28.2in) |
|
H |
225 mm (8.9in) |
|
|
D |
599 mm (23.6in) |
|
|
Net weight |
17.0 kg (37.5lb) |
|
|
Accessories |
Quick Guide, Power Cord, CUBASE AI download information |
|
|
Options |
Expansion Card, Foot Switch (FC5) |
|
|
Others |
Operating temperature range: 0–40 °C, Storage temperature range: -20–60 °C |
|
Analog input characteristics
|
Input Terminals |
GAIN |
Load |
For Use With |
Input Level |
Connector |
balanced / |
||
|
Sensitivity*1 |
Nominal |
Max. before clip |
||||||
|
INPUT1-24 |
+66dB |
7.5KΩ |
50-600Ω‑ Mics |
-82dBu (61.6V) |
-62dBu (0.616mV) |
-42dBu (6.16mV) |
Combo Jack (XLR-3-31 type *2 |
Balanced |
|
-6dB |
-10dBu (245mV) |
+10dBu (2.45V) |
+30dBu (24.5V) |
|||||
|
ST IN 1,2 |
— |
10kΩ‑ |
600‑Ω Lines |
-30dBV (31.6V) |
-10dBV (316mV) |
+10dBV (3.16V) |
RCA Pin Jack |
Unbalanced |
*1. Sensitivity is the lowest level that will produce an output of +4dBu (1.23V) or the nominal output level when the unit is set to maximum gain. (All faders and level controls are at maximum position.)
*2. 1: GND, 2: HOT, 3: COLD
*3. Tip: HOT, Ring: COLD, Sleeve: GND
*In these specifications, 0dBu = 0.775Vrms.
*+48V DC (phantom power) can be supplied to INPUT XLR type connectors via each individual software controlled switch.
Analog output characteristics
|
Output Terminals |
Source |
For Use With |
Output Level |
Connector |
balanced / |
|
|
Nominal |
Max. before clip |
|||||
|
OMNI OUT 1-16 |
75‑Ω |
600Ω‑ Lines |
+4dBu (1.23 V) |
+24dBu (12.3 V) |
XLR-3-32 type *1 |
Balanced |
|
PHONES *3 |
100‑Ω |
40Ω‑ Phones |
3mW |
75mW |
Stereo Phone Jack (TRS) *2 |
Unbalanced |
*1.1: GND,2: HOT, 3: COLD
*2 Tip: LEFT, Ring: RIGHT, Sleeve: GND
*3 The position of the level control is lowered by 16dB from the maximum.
*In these specifications, 0dBu = 0.775Vrms.
*All output DA converters are 24bit, 128times oversampling.
Digital input/output specifications
|
Terminals |
Format |
Data length |
Audio |
Connector |
|
USB (TO HOST) |
USB |
24bit |
34ch input / 34ch output, PCM |
USB (B type) |
|
iPad |
USB |
— |
Playback: MP3 or WAV file data / Record: WAV file data |
USB (A type) |
Control I/O specifications
|
Terminals |
Format |
Level |
Connector |
|
NETWORK |
IEEE802.3 |
10BASE-T/100Base-TX |
RJ-45 |
|
FOOT SW |
— |
— |
TS Phone |
All of our YAMAHA TF3 digital mixer comes with a 1 year local warranty