Model: A B C.please leave me the message of the model and the color you want , if not , ship randomly ,thank you
Model A detail:
1.Color: black with red, black, red.
2. Material: Aluminum + Leather
3.Product Dimensions: gear shift knob height 7 cm, mounting hole diameter of 8 to 12 mm, hole depth 4 cm, suitable for most cars. If you are worried about that it is not fit for , can firstly look at the amount of the original car ones.
4.Accessories: each piece of 8MM, 10MM, 12MM caliber rubber ring accessories+ Mounting screws 3 piece+ special wrench 1 piece, suitable for most models car available in the market
Model B detail:
1.Color: black with red line black with black line
2. Material: Aluminum + Leather
3. Diameter is 2.5cm, length 12cm
4.Accessories: each piece of 8MM, 10MM, 12MM caliber rubber ring accessories+ Mounting screws 3 piece+ special wrench 1 piece, suitable for most models car available in the market
Model C detail:
1.Color: red line
2. Material: Aluminum + Leather
3.size: Height 10cm, top about 5.5cm * 5.2cm;Diameter is 1.5cm (with three different caliber rubber ring and screws)
4.Accessories: each piece of 8MM, 10MM, 12MM caliber rubber ring accessories+ Mounting screws 3 piece+ special wrench 1 piece, suitable for most models car available in the market
Attention:
1. This product is suitable for most of manual transmission car, part of the automatic transmission(AT) gear head is also available! NOTE: (This gear Knob is fit for the basic models car except the ones whose reverse is on the first gear,it means that when reverse, must be lift up) ,please have a look at your gear Knob before your buying
2. with button lock temporarily unable to install!
3. This gear head for most manual transmission models, after the installation of the original car stalls on the head can not fully put the dust cover situations. Gear head section is modified pieces, each vehicle's gear head dust cover structural design are not the same, modified gear head is impossible with dust cover all models are adapted to structural design, unless it is a genuine car-specific gear head . Therefore, after the installation of dust jacket are too long or too short is a normal situation.if can not accept this situation ,think carefully before buying.
4.different model, the size is difference.
installation Method:
1 Remove the original car stalls head
2 take off the aluminum cover from the end of this gear knob
3 take rubbe ring which is fit for the gear lever
4 turn the rubber ring into gear lever
5the gear head directly set into the gear lever(note:please put the aluminum cover into the gear lever firstly )
6set up the small screw
7 with hexagonal screws tighten
8, the aluminum cover can be tightened up
If not appropriate, select a most fit size ones ,and then fix it at a suitable position with 3M tape. after the 3M tape firmly, put the shift knob mounted on it
