








Product Description
Assembly instructions
• Combine the 2 sections of the stake. Then push the stake into the ground until the top collar is even with the ground surface. (PLEASE NOTE: If the ground is hard and packed, moisten the ground with water before inserting the stake to avoid breakage.)
• Adjust the angle of the LED projector light by loosening and then tightening the angle adjustment knob.
• Insert the adjusted projector light to the stake.
• Connect the 2-pin plug of the power cord to the projector power inlet insuring proper polarity. To avoid water getting in, make sure to turn the plug cap clockwise until secure.
• Connect the adapter to a UL listed extension cord or to a UL approved electrical outlet.
Specifications:
• Input: 120V 60 Hz AC, Output: DC 5V 2A 9W
• Projector Classification: Class 3R
• Maximum Power Output: Less than 5mW
• Wavelengths: 532 nm, 650 nm
• Projection Coverage: Over 3000 sq.ft.
• Operating Temperature Range: - 31 ℉to 104 ℉( -35℃ to 40 ℃)
• This projector works with an Auto - Timer Feature
Packing List
1 * Red and Green Stars Projectors Light
1 * Ground Stake
1 * Remote Control
1 * Indoor Base
1 * Power Cable
1 * User Manual
Please Note!!!
In cold weather (at or below about -20 ℉), the projector light will be dim when first turned on. The projector light will operate normally after warming up - which may take 10 to 20 minutes.
Feature
ULTRA LARGE COVERAGE: OVER 3000 square feet area, 33 Feet is A better distance from the projection surface to this projector light; Decorate Tree, Flower, Wall, Lawn, Fountain, Signboard and More.