SPECIAL EDITION HANDY BABY , CUSTOMED MADE FOR SINGAPORE / MALAYSIA / INDONESIA / THAILAND / VIETNAM AND PHILIPPINES
SHIPMENT FROM SINGAPORE. 100% AFTERSALES SUPPORT, WITH POWERFUL ENGINEERING TEAM .
Dealership Option

Programming Instructions:

 

If you have anti-theft, you will need to have at least ONE WORKING REMOTE already before you can program any others. (Note that all models above the DE have anti-theft as standard feature). If you don’t have one working remote, then you will have to go to a dealer or auto-locksmith to have the remotes programmed.

Instructions for anti-theft with at least one working remote:

  1. With your one working remote, press the ‘UNLOCK’ button,
  2. wait about 5 seconds, then press the ‘LOCK’ button
  3. immediately press the ‘UNLOCK’ button again
  4. on the new NON WORKING remote, press and hold both the ‘LOCK’ and ‘UNLOCK’ buttons for 3 seconds
  5. release both buttons at the same time and IMMEDIATELY press the ‘UNLOCK’ button again.

You are done, programming mode will end within two minutes or when you start the car.

If you don’t have anti-theft enabled, then you can enable programming mode for your remote door opener by doing the following:

  1. Find the car’s data programming port. This is located under the drivers side dash – It’s a white connector with 16 holes.
  2. Put the key in the ignition. Leave it in the “Off” position.
  3. Put the jumper wire pin into data port slot four. Put the other end of the pin into data port one.
  4. IMMEDIATELY, turn the ignition switch to ON (with the jumper wire still connected in the data port)
  5. IMMEDIATELY, press the hazard switch 6 times (at which time the door locks will cycle on and off to indicate that the car is in ‘program’ mode)
  6. Push “Lock” on the remote three times within 10 seconds. The door will lock and unlock to indicate it has been programmed.
  7. Do the same for the second key
  8. Remove the jumper wire from the data port and remove the keys from the ignition and you are done.
For most car owners, the steps above will work to program their new key. If it doesn’t or if the steps above don’t make sense, check out your local dealer. They program keys all the time and can help with any issues that come up.
Your local dealer is also a great resource for finding to the best quality replacement keys offers. They can also make sure these keys work properly.
Having two sets or more of keys for your vehicle is extremely handy in those situations where you might have locked your keys in your car or another driver is using the car. Taking the time to make sure the new key works properly will save you a ton of hassle down the road.
If it dose not work free feel to call for Tech Support!