?????

Dimensions: 13CM * 3.5CM

Features:

1， using the flexible printed circuit boards and double-sided adhesive， can be mounted on the rear-view mirror has a curvature of the surface.

2， can be accessed by turning lights or small lights in combination.

3， high temperature， waterproof material， durable.

4， the use of ultra-thin， ultra-bright LED.

 

Installation instructions:

Method (a): the mirror must be removed

1， the first of this product with the same bent mirror arc.

2， and then forced posted up.

3. Remove the car tripod.

4， loose screws， remove the mirror.

5， the wire through the hole from the tripod into the car.

6， the use of double-sided adhesive fixed wire below the mirror， it is not easy to see the wires.

7， use the wire to the engine room void， connected in a small lamp.

8， perfect installation.

Method (b): Does not have to split the mirror

1， the first of this product with the same bent mirror arc.

2， and then forced posted up.

3， using double-sided adhesive fixed wires underneath the mirror， it is not easy to see the wires.

4， wires attached to the door along the side mirror.

5， use the wire to the engine room void， connected in a small lamp.

6， a perfect installation.

7， can still be seen from the rear lights.

 

Note:

1， posted before this product， please use scouring oil wipe the mirror surface.

2. When connecting wires， please pay attention to distinguish the polarity of the wires， the wires are properly connected.

3， if the mirror is folding mirrors， please set aside long enough to lead.

4， wires should be fixed to avoid the broken wire at the door.