| Color | Black Blue |
| Brand | ZnDiy-BRY |
| Model | All-in-one V2.0 |
| Material | PCB + Plastic |
| Quantity | 1 Piece |
| Compatible Model | Flight Controller |
| Other Features | Supported MegaPirateNG/ ArduCopterNG???/ArduPlaneNG/MultiWii/AeroQuadand firmware;Up to 8-axis motor output;8 input channels for standard receiver and PPM SUM;4 serial ports for debug/Bluetooth Module/OSD/GPS/telemetry;2 servos output for PITCH and ROLL gimbal system;A servos output to trigger a camera button;6 Analog output for extend device;A I2C port for extend sensor or device;Separate 3.3V and 5V LDO voltage regulator;Built-in 16Mbit data flash memory chip to record the data automatically;ATMega 2560-16AU Microcontroller;MPU6050 6 axis gyro/accel with Motion Processing Unit;HMC5883L 3-axis digital magnetometer;MS5611-01BA01 highprecision altimeter;FT232RQ USB-UART chip and Micro USB receptacle;On board logic level converter.Input power selection:One of the following ways;Connect 5V power cable from ESC or UBEC to the ESC/Servo port、 the J1 jumper must be closed.Connect 5V~12V power cable to the extend power port、 the J1 jumper must be removed.When using Extend Board、 AIO PRO must be powered from the extend power port |
| Packing List | 1 x Flight controller 1 x 3Pin to 3-Pin cable (10cm) 3 x 3Pin to 1-Pinx3 cables (10cm) 1 x 1.25mm 4-Pin cable (14cm) 1 x 1.25mm 6-Pin cable (14cm) 1 x 1.25mm 8-Pin cable (14cm) |