Assembled ZVS Tesla simple inverter drive Jacobs Ladder 5-12v

Features:

1.The 12 v induction heating: maximum power 100 w.

2.Pushed the ignition coil when the 12 v， 30 w.

3.PCB size: length * width * 55 mm * 37 mm * 1.6 mm thick

4.No-load current completely around 26 ma (completely empty: don\\\'t answer the ignition coil， heating coil， etc.).

5.When the input DC 12 v: pull arc 2 cm， longest maximum current of 2.5 or less A， don\\\'t pull the arc current 0.25 A. (primary 5.5 5.5 T + T)

6.After heating coil， we use length * width * height 30 * 10 * 4 mm iron heat measured

.maximum current of 7.8 A， heated to red when the current is 6.4 A. After the heating coil around 12 v load current is 1.6 A spacetime. (the number of turns of 5.5 5.5 T + T)

7.When the input DC 12 v: push the ignition coil continuous arc 1 hour，

Note;

When the induction heating， the general would work five minutes to cool off. Because the induction heating current is relatively large， the heating coil is relatively large. Part of the heat when heated， heated objects generated will be passed heating coils， over time， the heating coil temperaturewill be high. If the heating coil is connected to the terminals， then the plastic part will melt awaythe terminals! Therefore， the best heating coil soldered directly to the PCB board when the induction heating
package:
1pc Assembled ZVS Tesla simple inverter drive Jacobs Ladder 5-12v

';